Control Panel; Standard Mode - KEYTEK CTS 2000 Instruction Manual

CONTROL PANEL

The control panel of your instrument has been designed for maximum ease of use and therefore
most of the controls are associated with a single function, the only dual-function buttons are those
on the right-hand side of the panel. They are used both for preset selection and for special
programming functions, which we will see later.
The CTS 2000 is also equipped with a 2-line by 16-character LCD display that will show the type and
number of presets enabled, information needed to edit presets or help messages.
A special memory bank constantly updates the status of the control panel. Thanks to this function,
when you switch off the instrument, the panel situation immediately preceding the switch-off will be
stored.
The same applies in the event of a sudden power failure.
When you switch on your instrument, it will automatically switch back to the way it was when it was
switched off, recalling all the controls activated before switching off.
WAYS OF USING THE INSTRUMENT
Your instrument is supplied with pre-programmed internal presets divided into two banks (A and
48
of presets each.
B) 24
In addition, there are expansion cartridges (optional) on which you can record a further 48 presets.
The cartridge supplied with the instrument contains a copy of the internal presets provided by the
manufacturer.
The CTS 2000 basically has three operating modes, namely Standard Mode, Edit Mode and Record
Mode.

STANDARD mode

This is the instrument's normal operating mode. You can recall both internal and cartridge presets
and enable the main functions.
EDIT mode
In this way you can temporarily edit all presets or create new ones using the parameters shown in
the graphic matrix to the right of the control panel above the preset selectors.
RECORD mode
It allows you to record, and thus make permanent, changes made to a preset.
STANDARD MODE
The Standard mode is automatically selected at power-on regardless of the mode the instrument was
in at the time of power-off.
Presets (Selection of presets)