KEYTEK CTS 2000 Instruction Manual page 10

CARTRIDGE
NOT PRESENT
If you press the button when the cartridge is inserted, the message appears:
CRT PRESET 1A
XXXXXXXX
In this case you will have recalled cartridge preset no.1, Bank A, named XXXXXXX.
Once you press the Cartridge button to recall any cartridge preset, as with internal presets, select the
Memory Bank (using the BANK A/B button to select Bank) and then press the button corresponding
to the desired voice number (1 to 24) or vice versa.
To return to the internal presets, simply press the Internal button.
In conclusion, to recall any internal or cartridge preset, you must select the memory source with the
internal or cartridge buttons, press the BANK A/B button (bank selector) and then the button
corresponding to the desired item number (1 to 24).
A different way to change presets is to press the UP and DOWN buttons in the FINE CONTROL
section. In this case you can sequentially enable all 48 internal or cartridge presets.
CAUTION: Since the current preset is loaded into the synthesizer's memory, it is possible to use a
cartridge preset, turn the instrument off, remove the cartridge, then turn the instrument back on and
still have the cartridge preset in memory.
If you now try to recall a preset without selecting the internal memory (INTERNAL), the display will
show:
CARTRIDGE
NOT PRESENT
However, the previous cartridge preset is still in memory.
To recall other presets, press the INTERNAL button and, if necessary, a button from 1 to 24.
Pitch
This wheel allows you to temporarily vary the pitch of the instrument within a programmable range
of values for each preset.
Modulation
This wheel allows you to vary the amount of modulation of the preset from a minimum
programmable value for each preset.
Midi