Preset Name - KEYTEK CTS 2000 Instruction Manual

Potentiometer C : Defines the number (nn) of the preset to be copied.
Potentiometer D : Defines the Zone (y) of the destination preset to be copied to.
Once all the necessary parameters have been defined, the operation must be completed by pressing
the ENTER button.
After pressing the Enter key, the display will show the following message for a few seconds:
The instrument will then exit the EDIT mode and automatically select the STANDARD mode by
recalling the preset on which the copy was made.
_________________________________________________________
Family No. 23 : NAME Display Fam. : EDIT
Group : NAME
________________________________________________________
This Parametric Family allows you to write a name (up to 10 characters) to associate with a current
preset, or to modify an existing name.
As soon as potentiometer A is moved after selecting the Parametric Family NAME, the display will
show the message:
-At this point, the individual potentiometers A and B will allow you to define:
Potentiometer A :
Potentiometer B :
Please note that in addition to the potentiometers, the UP and DOWN buttons in the Fine Control
section can be used to select the cursor position or character.

PRESET NAME

*PRESET NAME*
*x_xxxxxx*
Defines, by moving the cursor "_", which letter to write modify.
Defines the character to be written at the position indicated by the cursor.
You have at your disposal:
- the 26 characters of the English alphabet,
- the numbers 0 to 9,
- signs . - /
- the empty space.
COPY ZONES
COMPLETED