Record Mode - KEYTEK CTS 2000 Instruction Manual

For a complete list and explanations of the functions of each parameter, see the PARAMETERS LIST
section on page 22.
To exit the Edit (Parameters) mode at any time, simply press the PRESETS/PARAMETERS button or
the INTERNAL or CARTRIDGE button in the Presets section.
The display will return to show the type, number, bank, and name of the preset, indicating that you
have returned to Standard (Preset) mode.
A flashing rectangular symbol ( ) on the display (next to the bank letter A or B) indicates that the
preset has been changed.
Remember that Edit mode allows for TEMPORARY CHANGES, so changes made will be lost when
changing presets.
Recalling the preset itself will recall the one contained in the memory and not the one you have
modified. To make changes permanent, it is therefore necessary to use the RECORD function before
changing presets (see RECORD MODE section).

RECORD MODE

As we have already mentioned, Record mode allows you to record, and thus make definitive,
changes made to a preset.
ATTENTION
When you record to a preset, you will lose its previous contents. Therefore, before making a
recording, compare the new preset to be stored with the preset in the memory to be erased.
This operation is carried out using Parametric Family No. 24 EDIT/COMPARE.
It is possible, however, to reload all or part of the 48 presets provided by the instrument using the
Cartridge supplied with the instrument, which contains a copy of the original presets.
Enabling registration
IMPORTANT
When switched on, the instrument is not enabled for preset recording as it is equipped with a special
software protection.
If you attempt a Write, Glocal Back-up, Copy or Zone Copy operation without removing the software
protection, the display will show the following message for a few seconds:
WRITE DISABLE
SELECT PARAM.21
To enable the instrument for recording, proceed as follows :
- Enter Edit Mode by pressing the Preset/Parameter button,
- Select the WRITE & C. Parametric Family. By pressing the n21. key, the display will show :
WRITE /COPY
- Slightly move potentiometer A associated with the ENABLE /DISABLE parameter, the display
will show the message: