KEYTEK CTS 2000 Instruction Manual page 20

- By pressing the ENTER button, you can definitively confirm the recording and the display will
show the message for a few seconds:
WRITE COMPLETED
The instrument will then automatically exit the recording mode and return to the Standard mode by
clicking the new registered preset.
- Pressing the WRITE button will allow you to exit the recording phase without having
completed it and the display will show the message for a few moments:
WRITE ABORTED
The instrument will then automatically return to the Standard mode of operation, showing the
starting preset.
Global recording of all instrument presets
This operation (GLOBAL BACKUP) allows you to record and transfer, in a single operation, all the
contents of the instrument's internal memory to an external cartridge (RAM Cartridge only) to the
internal memory.
All recording operations are performed with the instrument in Standard mode.
IMPORTANT
When switched on, the instrument is not enabled for preset recording as it is equipped with a
special software protection.
If you attempt a Write, Glocal Back-up, Copy or Zone Copy operation without removing the software
protection, the display will show the following message for a few seconds:
WRITE DISABLE is
SELECT PARAM.21
Global Backup from Internal Memory to Cartridge
- Insert a RAM Cartridge into the RAM Cartridge slot.
- Use the first switch on the cartridge to select the deck (1 or 2) on which you want to record.
WARNING, each recording operation deletes the previous content.
- Enable the cartridge for recording by setting the second switch to the ON position.
- Check that the synthesiser has also been enabled for recording (See paragraph Enabling
recording page 18).
- Press and hold the ZONE GLOBAL button in the Presets section.
- Press and hold down the INTERNAL button in the Presets section, the display will then show :
GLOBAL BACK-UP
PRESS WRITE
- While holding down the Zone Global and Internal buttons, press the WRITE button. The
display will show the following message:
FROM INT TO CRT