KEYTEK CTS 2000 Instruction Manual page 11

Using these two buttons, you can manage the Midi functions immediately, enabling or disabling the
transmission and reception of signals and selecting the mode of transmission and/or reception of
Program Change messages.
On/off Enables or disables Midi transmit and receive mode.
Midi Local/Remote
By pressing one or more times this button next to the Control Display, you can select the
transmission and/or reception mode of programme changes as follows:
If LOCAL mode is selected, the instrument will not transmit or receive program changes via MIDI, but
will only be able to change its own internal presets.
Selecting the REMOTE mode will allow the instrument to transmit and receive program changes via
MIDI, but it will not be able to change its internal presets.
Selecting the LOCAL & REMOTE mode will enable the instrument to transmit and receive program
changes via MIDI, and will also enable it to change its internal presets.
Both the Midi On mode and the Local, Remote and Local & Remote functions are indicated by two
special symbols (* = enabled, 0 = disabled ) placed on the right-hand side of the display in
correspondence with the relative labels:
Midi Off INT PRESET 1A _ _ Local
Midi On INT PRESET 1A * _ _ Local
Local
Midi On
Remote
Midi On
Local & Remote PIANOFORTE * _ _ Remote
Release Pedal
The CTS 2000 comes with a footswitch to control the RELEASE function.
This function allows the sound to be maintained and decayed slowly, even after the keys have been
released, with a different programmable decay for each preset.
The Release Pedal is only active when the pedal is pressed.
PIANO _ _ Remote
PIANOPHONE 0 _ _ Remote
INT PRESET 1A 0 _ _ Local
PIANO * _ _ Remote
INT PRESET 1A * _ _ Local