KEYTEK CTS 2000 Instruction Manual page 79

Omni On, Mono
Messages will be acknowledged by all units regardless of transmission channel, but with control of a
single monaural voice, all units will play the same monaural voice.
Omni Off, Poly
Messages will only be acknowledged by slave units that have the same Midi channel number as the
sent signal and are assigned in polyphony.
Omni Off, Mono
Messages will only be acknowledged by slave units that have the same Midi channel number as the
sent signal and are assigned in monaural.
The CTS 2000 MIDI
Your instrument has been enabled to transmit and receive most of the possible signals of the Midi
system, namely :
In transmission
Note ON / Note OFF with dynamics signal
Transposition of Note Values
Program Change 0 to 127
Control Change of Pedal Release
Pitch Bender
Modulation
In reception
Note ON / Note OFF and dynamics signal
Program Change from 1 to 96 on Midi RX channel of Zone 0
Control Change of Pedal Release
Pitch Bender
Modulation
The CTS 2000 has a 61-key keyboard and is therefore enabled to transmit and/or receive notes from
C 0 to C 5.
If you wish your instrument to transmit and receive Midi notes from C 1 to C 6, you must switch on
the CTS 2000 by pressing and holding down button 19 for the Midi family, this mode will remain
enabled until the instrument is switched off.
IMPORTANT