KEYTEK CTS 2000 Instruction Manual page 7

MONO
Selecting this mode sends the sound to a single audio output.
Once you have chosen the type of connection to be made, proceed as follows:
Set the volume of the instrument and amplification or audio mi xer to zero and proceed to one of the
following connections :
Stereo
Connect, via two ¼ jack-jack cables, the Right and Left outputs to two inputs of the amplifier or mixer
respectively.
Mono
Connect the mono output to an amplifier or mixer input via two ¼ jack cables.
Midi
Use the three available MIDI sockets to make the desired type of connection with other MIDI-
compatible devices or instruments (see MIDI section on page 59).
Accessories
Connect the Release pedal (supplied) to the Release pedal socket on the rear panel.
Connect, if necessary, a stereo headphone with 1/4" jack to the corresponding socket on the rear
panel. Connect the Expansion Cartridge (optional).
IGNITION
Once you have made the necessary connections, switch on your instrument first, followed by all the
other instruments connected to it via MIDI, and lastly the amplification.
BALANCING OF VOLUMES
Set the Volume control to about 3/4 of the way up and then adjust the amplification volumes to the
desired level.
In special cases, adjust the volume level of the instrument to vary the sensitivity of the input signal in
the amplifier.
ACCORDING
Your instrument is delivered already tuned to the frequency of 440hz and therefore does not need
tuning. In some special cases, especially when playing together with acoustic instruments, it may be
necessary to retune your instrument.
In this case, turn the TUNE potentiometer on the rear panel as follows:
Clockwise ....................... increases frequency (higher sound)
Counterclockwise ................ decreases Frequency (lower sound)