KEYTEK CTS 2000 Instruction Manual page 19

WRITE
DISABLE
At this point the instrument is enabled to record new programmes and will remain so until it is
switched off or deliberately returned (with the same operations) to the WRITE DISABLE position.
- Then exit the Edit mode by pressing the PRESETS/PARAMETERS button or the INTERNAL or
CARTRIDGE button in the Presets section.
The display will return to the type, number, bank, and name of the preset, indicating that you have
returned to Standard mode.
Recording a preset
ATTENTION
Presets can only be recorded in the same Bank (A or B both Internal and Cartridge) from which they
were created.
All recording operations are performed with the instrument in Standard mode.
When you have recalled and edited a preset, exit Edit mode and return to Standard mode, and press
the WRITE button to store the preset in memory:
WRITE INT PRESET opurre WRITE CRT PRESET
Xxx IN INT ( ) yyyy xxx IN CRT ( ) yyyy
Depending on whether the preset you select belongs to the Internal or Cartridge presets.
xxx = number and bank of the preset you called up
yyy = number and bank of the preset to which you intend to record by deleting its previous content
( ) = flashing rectangular symbol
xxx and yyyy have the same value because normally the modified preset is recorded instead of the
original one.
If you wish to record the preset to another memory, simply select the preset number you wish to
record to using buttons 1-24 (this will change the yyyy value) and the location (INTERNAL or
CARTRIDGE) using the Internal or Cartridge buttons.
After selecting the number and location of the preset to be recorded, proceed with the recording
operation as follows:
- Press the ENTER button or WRITE button once.
The display will show the message:
ENTER TO RECORD
WRITE TO ESCAPE
At this point :