KEYTEK CTS 2000 Instruction Manual page 47

Function : Determines the cutoff frequency at which the filter of each item is to be brought up from
the
previous Break Point cut-off frequency value in the time set by the
Slope parameter.
If the Sustain value is equal to the Break Point value, the slope function will be
ineffective.
Parameter : RELEASE/PED
Power meter : F
Display Par. RELEASE TIME F ( z )
OLD xx NEW yy
Value xx/yy : 1 to 31 + inf.
Function : Determines the time it takes for the filter of each item to return from the frequency
the shear rate determined by the Sustain parameter, to that determined by the
Cut-Off after key release, the Release time applies even if the key is released.
released before the Attack, Decay and Slope phases have been completed.
If the Sustain cut-off frequency is set to 1 (minimum value) and the Attack ,
Decay and Slope have been completed, the Release function will be non-existent.
If the Release value is set to inf. (infinity) the cut-off frequency of the filter
will remain at the level at which the filter has reached when the button is released.
ATTENTION : With this parameter you can also set a second time of
Release, different from the keyboard release, which will be activated by pressing the
RELEASE PEDAL.
The Pedal Release value is selected by holding down the Pedal during
the value setting phase.
As soon as the pedal is pressed, the display will show :
RELEASE TIME Fp (z)
OLD xx NEW yy
The lower case p next to Time 2 indicates that you are selecting the value of
Pedal Release (NEW) while the OLD value will be the one previously
assigned to the pedal itself.