KEYTEK CTS 2000 Instruction Manual page 46

Break Point, Slope and Sustain functions will be enabled.
Parameter : BREAK POINT
Power meter : C
Display Par. BREAK POINT F ( z )
OLD xx NEW yy
Value xx/yy : from 1 to 64
Function : Determines the cutoff frequency at which the filter decay function of each item must
stop. The Break Point is an adjustment of the cut-off frequency value and not of
time such as Attack, Decay and Release.
Parameter : SLOPE
Power meter : D
Display Par. SLOPE TIME F ( z )
OLD xx NEW yy
Value xx/yy : 1 to 31 + inf.
Function : Determines the time it takes for the filter of each item to move from the frequency of
the breakpoint parameter to that established by the breakpoint parameter.
Sustain.
If the value of the Sustain parameter is greater than the Break Point with the Slope
we can determine the time of a second attack.
If the value of the Sustain parameter is less than the Break Point with the Slope
we can determine the time of a second Decay.
If the Slope value is set to inf. (infinity) ) the filter cut-off frequency
will remain the one determined by the Break Point parameter and will be held until
the release of the
key and the Sustain function will not be enabled.
Parameter : SUSTAIN
Power meter : E
Display Par. SUSTAIN LEVEL ( z )
OLD xx NEW yy
Value xx/yy : from 1 to 64