KEYTEK CTS 2000 Instruction Manual page 70

After pressing the Enter key, the display will show the following message for a few
seconds:
and then display again:
Parameter : LFO 1 < > 2
Power meter : E
Display Par. COPY: LFO1 ( z ) or COPY: LFO2 ( z )
TO LFO2 TO LFO1
Value xx/yy : 1 to 2 or 2 to 1
Function : Allows you to select the function of complete copying of the parameters of the Families
Group LOW FREQUENCY OSCILLATORS from LFO1 to LFO2 and vice versa
defining the direction (from where to where) of the copy.
Once the copy direction has been defined (for the current Zone (z)) the operation
must
be completed by pressing the ENTER button.
After pressing the Enter key, the display will show the following message for a few
seconds:
and then display again:
FRQ EG COPY
COMPLETED
WRITE/COPY
LFO COPY
COMPLETED
WRITE/COPY