Installation
30
3.5.5 IQ sensor with SNCIQ cable
NOTE
The sensor cable may only be connected to the SENSORNET connector. No
wire of the cable may be connected with an external electrical potential. Other-
wise, malfunctions could occur.
1
On the left-hand side of the DIQ/S 281, remove the two countersunk
screws and open the enclosure.
SENSORNET
figure 3-14 Connecting the cable (example DIQ/S 281CR2)
2
Screw the cable gland (pos. 1 in figure 3-14) with the sealing (pos. 2)
into the housing at the mounting position for the SENSORNET
connection (see label on the bottom of the housing)
3
Loosen the cap nut (pos. 3 in figure 3-14).
4
Feed the sensor cable through the cable gland into the enclosure.
2
1
3
Sensor
DIQ/S 281
X3
X2
X1
SENSORNET 1
ba76226e02
03/2023