Xylem DIQ/S 281 Operating Manual page 27

DIQ/S 281
Materials required
Tools
Preparing the
cable ends
ba76226e02
 1 x SNCIQ or SNCIQ/UG connection cable (see chapter 10 A
)
AND OPTIONS
 Wire end sleeves for 0.75 mm
tool
 1 x cable gland with seal (scope of delivery of MIQ module).
 Cable stripping knife
 Wire stripper
 Phillips screwdriver
 Small screwdriver.
1 Cut off the cable to the required length.
2 Remove approx. 45 mm of cable insulation (in the case of the SNCIQ/
UG earth cable, remove both the inner and outer insulation).
3 Only for the SNCIQ/UG earth cable:
strip the outer insulation for a further 35 mm.
4 Shorten the exposed shielding braid up to the cable sheath.
5 Shorten the two fillers (plastic inlays) up to the cable sheath.
6 Bare the red and green wires and fit them with wire end sleeves.
7 Fit the filler stranded wire with a wire end sleeve.
SNCIQ
SNCIQ/UG
figure 3-11 Prepared cable end
03/2023
2
wire cross-section with matching crimping
~ 35 mm
~ 45 mm
~ 45 mm
Installation
CCESSORIES
27