Xylem DIQ/S 281 Operating Manual page 48

Installation
48
X19 X18
24V AC DC
INPUT
POWER
figure 3-30 24 V AC/DC connection.
The complete assignment of the terminal strip is shown in
section 3.12.
8 Connect wires 1 and 2 to the terminal strip. Make sure that the cable
assignment agrees with the specification on the terminal label under the
terminal strip.
9 Tighten the cap nut (pos. 3 in figure 3-29).
No free wires are allowed to project into the housing. Otherwise there is the dan-
ger of short circuits that can cause a fire. Always cut off any wires that are not in
use as closely as possible to the cable gland.
10 Close the enclosure of the DIQ/S 281.
DIQ/S 281
ba76226e02
03/2023