Xylem DIQ/S 281 Operating Manual page 35

DIQ/S 281
Mounting the sun
shield on a
mounting stand
Premounting the
ISO blind nuts
ba76226e02
2
3
4
figure 3-18 Mounting the SSH/IQ sun shield on a mounting stand
1 Screw the sun shield (pos. 1 in figure 3-18) with the four hexsocket head
screws (pos. 2), the washers (pos. 3) and the clamps (pos. 4) at the
required height on the mounting stand from the back.
7
5
figure 3-19 Mounting the sun shield: Premounting the ISO blind nuts
2 Remove the two countersunk screws (pos. 5 in figure 3-19) and swing
open the lid.
3 Insert the cheese-head screws (pos. 6 in figure 3-19) with the plastic
washers in the drilled mounting holes and loosely screw in the ISO blind
nuts (pos. 7).
03/2023
1
6
Installation
35