Table of Contents
Advertisement
DIQ/S 281
ba76226e02
figure 3-17 SENSORNET connection
5
Connect the cable ends to the terminal strip. At the same time, look out
for the designations of the terminals (red / shield / green).
6
Tighten the cap nut (pos. 3 in figure 3-14).
7
Close the enclosure.
The complete assignment of the terminal strip is shown in
section 3.12.
For further instructions on the mounting of the sensor at the applica-
tion location, please refer to the relevant manual (immersion depth,
etc.).
3.6
On-site mounting of the DIQ/S 281
3.6.1 General information
The universal transmitter DIQ/S 281 is designed for stationary installation. With
the aid of mounting accessories, the setup can be adjusted to meet various
requirements.
NOTE
Components installed outside must always be protected by a sun shield against
the effects of the weather (snow, ice and direct solar radiation). Otherwise, mal-
03/2023
X3
X2
X1
SENSORNET
schwarz
grün
rot
Sensor
Installation
33
Advertisement
Table of Contents
