Table of Contents
Advertisement
Outputs
Function
Settings
120
9
Using < > and <OK>, highlight and confirm
The new settings are stored.
Recorder
6.7.1
The measured values of the linked sensor at the current output are set up as cur-
Recorder
rent intensity in the
Recorder type
down in the
Setting
Selection/Values
Recorder type
0 to 20 mA or
4 to 20 mA
Start value
(sensor
dependent)
End value
Measured
Main variable
variable
Adjoining variable
Attenuation
0 ... 40 mA/s
I -> UFL/OFL
Error
Limitation
Behavior at error
Fixed current
value
Unchanged
application. The output of measured values is laid
Start value
End value
,
and
Explanation
Minimum spacing:
≤ 5 % of the measuring range
(sensor-dependent)
Main variable
measured parameter of the sensor
(e.g. pH, oxygen, etc.).
Adjoining variable
additional measured parameter (e.g.
temperature).
Speed of change of the output
current (mA/s) in the case of erratic
changes of the input signal.
Current values outside the range
between
are regarded as an error. The current
output reacts as specified under
Behavior at error
The current at the output is limited to
Start value
the
In the case of system errors and
sensor errors, the current output
delivers the fixed current value that
was specified.
Possible values:
0 ... 21 mA.
The current at the output remains
unchanged.
DIQ/S 281
Save and quit
settings.
designates the actual
designates an
Start value
End value
and
(see below).
End value
or
.
ba76226e02
.
03/2023
Advertisement
Table of Contents
