Removing The Bridge Cards - Dell PowerEdge R760xa Installation And Service Manual

Figure 103. Installing the sponge
Next steps
1. Install the rear mounting front PERC
2. Follow the procedure listed in

Removing the Bridge Cards

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the rear mounting front PERC
NOTE: Observe the cable routing before disconnecting the cables.
4. Remove the sponges.
5. Remove the GPU riser
6. Number of bridge cards vary as per the GPU.
7. Slot priority for GPU card installation without bridge cards: slot 31, slot 36, slot 33, and slot 38.
8. Slot priority for GPU card installation with bridge cards: slot 31, slot 33, slot 36, and slot 38.
NOTE: For more information about supported GPU cards and their slot priority, see
Steps
1. Holding the edges, pull the bridge cards out of the GPU cards.
module.
After working inside your
Safety instructions.
Before working inside your
module.
module.
system.
system.
Installing and removing system components
expansion card installation guidelines.
137