Table of Contents
Advertisement
Figure 82. Installing an expansion card into the expansion card riser
Next steps
1. If applicable, connect the cables to the expansion card.
2.
Replace the expansion card
3.
Replace the air
shroud.
4. Follow the procedure listed in
5. Install any device drivers required for the card as described in the documentation for the card.
Removing R1 and R4 paddle cards
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the air
shroud.
4.
Remove the cooling fan cage
NOTE:
Observe the cable routing before disconnecting the cables.
5. Remove the paddle card cable from side wall bracket.
6. Disconnect the power cable connected on the paddle card.
NOTE:
It is not recommended to disconnect paddle card slimline cables from the GPU riser modules, only disconnect from
the system board.
Steps
Press the blue release tab on the paddle card and holding the edges lift the paddle card from the riser connector on the system
board.
82
Installing and removing system components
riser.
After working inside your
Safety
instructions.
Before working inside your
assembly.
system.
system.
Advertisement
Table of Contents
