Installing The 2 X 2.5-Inch Rear Drive Module - Dell PowerEdge R860 Installation And Service Manual

Figure 41. Removing the 2 x 2.5-inch rear drive module
Next steps
1. Replace the 2 x 2.5-inch rear drive

Installing the 2 x 2.5-inch rear drive module

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. If required, remove the air
4. Remove the drives.
5. Disconnect the cables from the rear drive module.
NOTE: See cable routing
Steps
1. Align the slot on the rear drive module with the guide on the system.
2. Lower and press the rear drive module on top of the riser until firmly seated.
3. Using a Phillips #2 screwdriver, tighten the captive screws that secure the rear drive module into the system.
84 Installing and removing system components
module.
Safety instructions.
Before working inside your
shroud.
section for more information.
system.