Table of Contents
Advertisement
3.5.2
LAN/Ethernet
Specifications
Parameter
Ethernet connector
Protocols
Speed
3.5.3
USB-A port
Specifications
Parameter
USB connector
Function
Power
Standard
3.6
LED and Button indication chart
Button Backlight Status
Button
Standby button
Shutter button
LED Status
The LED status is located on the top side of the projector, near the IR receiver.
During normal operation the LED is unlit. In the event of a critical error or high temperature, the LED will display red.
By critical error, the projector cannot be restarted until the projector is disconnected from the power supply and then reconnected
again. If the reason for the error persist, the projector will again go to critical error status.
By high temperature, the projector will restart when it has cooled down, and temperatures are back within the normal operating
limitations.
R5906852 F80 SERIES 21/09/2017
Value
1 RJ45 Connector for projector control (not content)
DHCP, TCP/IP, UDP/P
10/100 Mbit/1000Mbit
Value
Type A
Firmware upgrade using USB sticks
Power 5V, max 1,5A (out)
USB 2.0
Color status
Blinking WHITE (slow)
Blinking WHITE (fast)
Solid WHITE
Blinking BLUE
Solid BLUE
Blinking RED
Off (no color)
Solid WHITE
Solid RED
3. Input & Communication
Description
Projector starts up (booting)
Firmware upgrade
Projector is in Standby mode
Projector goes to ON mode
Projector is ON
Error condition
Projector is OFF, starts up, or is in Standby
mode.
Projector is ON, shutter is open
Projector is ON, shutter is closed
21
Advertisement
Table of Contents
