Moving Into Position; Product Locator Installation Card - GE LOGIQ C Series Basic Service Manual

GE
D 5273008-100, R
IRECTION
3-3-1

Moving into Position

Do not tilt the unit more than 5 degrees to avoid tipping it over.
CAUTION
To avoid injury by tipping over. Set the monitor to the lowest position before moving.
In general, a single adult can move the LOGIQ C Series along an even surface with no steep grades.
At least two people should move the machine when large humps, grooves, or grades will be
encountered. (It is better to pull from the rear rather than push from the front of the unit). Before moving,
store all loose parts in the unit. Wrap transducers in soft cloth or foam to prevent damage.
Although LOGIQ C Series is a mobile machine, two people should move it over rough surfaces or up
and down grades.
3-3-2

Product Locator Installation Card

NOTE: The Product Locator Installation Card shown may not be same as the provided Product Locator
card.
3 - 6
9
EVISION
Figure 3-3 Product Locator Installation Card
Section 3-3 - Receiving and Unpacking the Equipment
LOGIQ C B S S
ASIC ERIES
M
ERVICE ANUAL