Moving Into Position; Adjusting System Clock - GE LOGIQ 500 Service Manual

GE MEDICAL SYSTEMS
REV 7
2–2–8 Moving into Position
Do not lift the unit by the Keyboard.
Do not tilt the unit more than 5 degrees to avoid tipping it over.
To avoid injury by tipping over. Set the monitor to the lowest position before moving.
Equipment Damage Possibility. Lifting the console by holding covers may damage the cov-
ers. Do not lift the console by holding any covers.
In general, a single adult can move the LOGIQ 500 along an even surface with no steep grades. At least two people
should move the machine when large humps, grooves, or grades will be encountered. (It is better to pull from the rear
rather than push from the front of the unit). Before moving, store all loose parts in the unit. Wrap transducers in soft
cloth or foam to prevent damage.
Although LOGIQ 500 is a compact and mobile machine, two people should move it over rough surfaces or up and down
grades.
2–2–9 Adjusting System Clock
Set the system clock for the LOGIQ 500 to the local time. For procedure of adjusting the system clock, refer to 4–3–3
Utility Menu, (A) TIME ADJUSTMENT, in Chapter 4, FUNCTIONAL CHECKS.
CAUTION
CAUTION
2–13
LOGIQ 500 SERVICE MANUAL
P9030TA
INSTALLATION