Moving Into Position; Adjusting System Clock; Product Locator Installation Card - GE LOGIQ A3 Basic Service Manual

GE H
EALTHCARE
D 5213326-100, R
IRECTION
3-2-2

Moving into Position

Do not lift the unit by the Keyboard.
Do not tilt the unit more than 5 degrees to avoid tipping it over.
CAUTION
Equipment Damage Possibility. Lifting the console by holding covers may damage the covers.
Do not lift the console by holding any covers.
CAUTION
In general, a single adult can move the LOGIQ A3 along an even surface with no steep grades. At least
two people should move the machine when large humps, grooves, or grades are encountered. (It is
better to pull from the rear rather than push from the front of the unit). Before moving, store all loose
parts in the unit. Wrap transducers in soft cloth or foam to prevent damage.
Although LOGIQ A3 is a compact and mobile machine, two people should move it over rough surfaces
or up and down grades.
3-2-3

Adjusting System Clock

Set the system clock for the LOGIQ A3 to the local time. For procedure of adjusting the system clock,
refer to Software Configuration Checks, in Chapter FUNCTIONAL CHECKS.
3-2-4

Product Locator Installation Card

Fill out proper customer Information on the Product Locator Installation Card. Mail this Installation Card
"Product Locator" to the address corresponding to your pole.
NOTE: The Product Locator Installation Card shown may not be same as the provided Product Locator card.
PRODUCT LOCATOR INSTALLATION CARD
3-10
Approv e d Docu m ent - 5213326-100TPH_r3.pdf Page 67 of 252
3
EVISION
Section 3-2 - Receiving and Unpacking LOGIQ A3
LOGIQ™ A3 S M
ERVICE ANUAL