Moving Into Position; Adjusting System Clock; Product Locator Installation Card - GE LOGIQ P6 Service Manual

GE H
EALTHCARE
D 5245279, R
IRECTION EVISION
3-3-1

Moving into Position

Do not lift the unit by the Keyboard.
CAUTION
Do not tilt the unit more than 5 degrees to avoid tipping it over.
To avoid injury by tipping over. Set the monitor to the lowest position before moving.
Equipment Damage Possibility. Lifting the console by holding covers may damage the covers.
CAUTION
Do not lift the console by holding any covers.
In general, a single adult can move the LOGIQ™ P6/P6 Pro along an even surface with no steep
grades. At least two people should move the machine when large humps, grooves, or grades will be
encountered. (It is better to pull from the rear rather than push from the front of the unit). Before moving,
store all loose parts in the unit. Wrap transducers in soft cloth or foam to prevent damage.
Although LOGIQ™ P6/P6 Pro is a compact and mobile machine, two people should move it over rough
surfaces or up and down grades.
3-3-2

Adjusting System Clock

Set the system clock for the LOGIQ™ P6/P6 Pro to the local time. For procedure of adjusting the system
clock, refer to the section 3-6-1-1 on page 15.
Fill out proper customer Information the Product Locator Installation Card. Mail this Installation Card
"Product Locator" to the address corresponding to your pole.
3-3-3

Product Locator Installation Card

NOTE: The Product Locator Installation Card shown may not be same as the provided Product Locator
card.
3
Figure 3-7 Product Locator Installation Card
Section 3-1 - Overview
LOGIQ™ P6/P6 P S
RO ERVICE
M
ANUAL
3-9