General Procedure; Power On/Boot Up; Power Off/ Shutdown - GE LOGIQ C Series Basic Service Manual

GE
D 5273008-100, R
IRECTION
Section 4-3

General Procedure

SYSTEM REQUIRES ALL COVERS
CAUTION
Operate this unit only when all board covers and frame panels are securely in place. The
covers are required for safe operation, good system performance and cooling purposes.
4-3-1

Power On/Boot Up

After connect the system to the electrical supply, the power is applied to the scanner. When the Control
panel Power On/Off key is pressed once, the System starts.
4-3-1-1 Scanner Power On
When power is applied to the scanner, power is distributed to the Cooling Unit, Control Panel, LCD,
Peripherals and the Back-end Processor.
4-3-1-2 Turn on the system
Press the Power On/Off switch at the front of the system once.
When the Power On/Off switch on the Control Panel is pressed once, the Back-end Processor starts
and the software code is distributed to initiate the scanner.
No status messages are displayed during this process.
4-3-2

Power Off/ Shutdown

NOTE: After turning off a system, wait at least ten seconds before turning it on again. The system may not be
able to boot if power is recycled too quickly.
4-3-2-1 Back-end Processor Power Down
To power down the system:
1.) Press the Power On/Off switch at the front of the system once.
4 - 2
9
EVISION
Figure 4-1 Power On/Off Switch
Section 4-3 - General Procedure
LOGIQ C S B S
ERIES ASIC
M
ERVICE ANUAL