Apply A Radio Profile To Each Radio - Nortel 2350 User Manual

c
In the Transmit Power box, specify the transmit power for the radio.
Note.
effect. The power level is controlled by Auto-RF.
d
If the AP has two radios, click Next and go to
11 Click Finish.

Apply a Radio Profile to Each Radio

When you create an AP, a new radio (or radios, depending upon the type of AP created) is added into WMS.
The radios use the default radio profile in WMS unless you create a new radio profile and apply it to each radio
on the AP.
For more information about creating a radio profile, refer to
Profile to It" on page 104. For more information about creating an AP, refer to
page 104.
To apply a radio profile to a radio
1
Select the Configuration tool bar option.
2
In the Organizer panel, click the plus sign next to the WSS.
3
Click the plus sign next to Wireless.
4
Select Radio Profiles.
5
In the Radio Profiles table, select the radio profile.
6
Click Properties.
7
Click the Radio Selection tab.
8
Select the radios in the Available Members list and click Move.
9
Click OK.
You have completed the necessary steps for configuring your RF environment.
If Auto-RF for power configuration is enabled, setting this value has no
Nortel WLAN Management Software 2300 Series User Guide
step 10. Otherwise, go to
"Create a Radio Profile and Map the Service
"Create Your APs" on
Using Auto-RF 107
step 11.