Compute And Place Aps - Nortel 2350 User Manual

31 In the Mobility Domain list, select the Mobility Domain that contains the APs used for this coverage area.
32 In the Radio Profile list, select the radio profile used for this coverage area.
The profiles available depend on the Mobility Domain you selected in
applies to all radios associated with the coverage area. If you type the name of a radio profile that does not
already exist, WLAN Management Software creates it.
33 In the Wiring Closet list, select the wiring closet that contains the WSS or switches to be connected to the
shared AP.
If the APs will be directly connected to WSSs, a wiring closet is required. If all the APs in the coverage
area will be indirectly connected to WSSs through the network, a wiring closet is not required.
34 In the Redundant Wiring Closet list, select the wiring closet that will provide redundant connection to the
AP. This is required for directly connected APs, if you require the APs to have redundant connections.
Otherwise, this is not required.
35 Click Finish to complete the wizard and create the coverage area. The coverage area is now displayed on
your floor.

Compute and Place APs

When you perform the Compute and Place procedure for one or more coverage areas, WMS automatically calculates the
number of AP you require and places them in appropriate locations on the floor. To do this, two calculations are
performed in WMS. One is based on capacity (traffic engineering) and the other is based on pure RF coverage (at a
given data rate).
Nortel WLAN Management Software 2300 Series User Guide
Using RF Planning 151
step 31. The profile you select