Place The Equipment; Configure Initial Wss Connectivity; Upload The Wss Configuration Into A Wms Network Plan - Nortel 2350 User Manual

102 Using Auto-RF

Place the Equipment

Unpack and physically install the WSSs and APs. For information about installing the equipment, refer to
Installation" on page 46.

Configure Initial WSS Connectivity

After installing a WSS, prepare it for WMS configuration and management by configuring IP connectivity between the
WSS and WMS. Use the Web Quick Start (if available) or enter the quickstart command at the CLI prompt.
For more information about configuring initial WSS connectivity, refer to the
Start Guide.
The WSS also requires an administrative certificate to enable WMS management access. If the switch does not already
have certificates, WSS Software automatically generates them during the first system boot using WSS Software Version
4.2 or later. You do not need to install certificates unless you want to replace those automatically generated by WSS
Software. (For more information, refer to "Certificates Automatically Generated by WSS Software" in "Managing Keys
and Certificates" of the Nortel WLAN 2300 System Software Configuration

Upload the WSS Configuration into a WMS Network Plan

Retrieve the basic configuration information added to the WSS and upload it into WMS.
To upload the WSS configuration into a WMS network plan
1
Select the Configuration tool bar option.
2
In the Task List panel, select Upload WSS.
3
In the IP Address box, type the IP address for the WSS.
4
In the Enable Password box, type the enable password for the WSS.
This password must match the enable password that was defined using the CLI command set enablepass.
For more information, see the
5
Click Next. The uploading progress is shown.
6
After the Successfully uploaded device message is displayed, click Next.
WMS uses its verification rules to check the switch's configuration. If an item in the configuration
generates an error or warning, WMS displays the error or warning message.
7
Review the verification messages to determine whether you will need to make changes to the switch's
configuration after uploading it into WMS.
8
Click Next.
9
Click Finish.
NN47250-101 (320665-G Version 02.01)
Nortel WLAN 2300 System Software Configuration
Nortel WLAN 2300 System Software Quick
Guide.)
Guide.
"Equipment