Nortel 2350 User Manual page 105

3
Click Next.
4
Select the AP model from the AP Model list.
5
To select the radio type for a single-radio model, click the AP Radio Type box and select one of the
following radio types:
• 11b—802.11b only
• 11g—802.11b/g
6
Click Next.
Note.
The non-editable number (1 or 2) indicates the radio number on the AP.
7
To select the radio type for a single-radio model, click the AP Radio Type box and select one of the
following radio types:
• 11b—802.11b only
• 11g—802.11b/g
8
Click Next.
9
Configure the radios
a
To enable the radio, select Enabled.
b
In the Radio Profile list, select the profile to which the radio belongs.
c
In the Channel Number list, select the channel number for the radio.
Note.
If RF Auto-Tuning for channel configuration is enabled, setting this value
has no effect. The channel number is controlled by RF Auto-Tuning.
d
In the Transmit Power box, specify the transmit power for the radio.
Note.
If RF Auto-Tuning for power configuration is enabled, setting this value
has no effect. The power level is controlled by RF Auto-Tuning.
e
If the AP has two radios, click Next and go to
10 Click Finish.
To create a Distributed AP in
1
Access the Create AP wizard
a
Select the Configuration tool bar option.
b
In the Organizer panel, click the plus sign next to the WSS.
c
Click the plus sign next to Wireless.
d
Select Access Points.
step
WMS
Nortel WLAN Management Software 2300 Series User Guide
Using Auto-RF 105
10. Otherwise, go to step 11.