Adjusting Cutting; Bidirectional Adjustment - Roland VersaSTUDIO SIGN MAKER BN-20 First Step Manual

STEP 2: Making Adjustments Before Output
Before output, perform printing tests and test cuts, and make the necessary
adjustments. This is required to make the most of BN-20's printing and
cutting capabilities. Perform this task before daily operations and when
changing the media type.
Important
The components of the white ink and metallic silver ink can separate
easily, so gently shake this ink cartridge each day before operations.
The other color cartridges do not have to be shaken each day, but be
sure to shake them when replacing. Failure to shake the ink
1.
Starting the adjustment


In the [Adjustment] tab, click [Adjust All].

Click [Next] on the displayed screen.
2.
Check for nozzle clogging

Click [Test Print].
The test pattern is printed. Follow the on-screen instructions to check
for nozzle clogging.
Nozzle is clogged  Proceed to
Nozzle is not clogged  Proceed to

Select [Normal Cleaning] and click [Go].
Normal cleaning starts.

To check for nozzle clogging again  Return to
If the nozzle clogging is not fixed, perform "Normal Cleaning" again.
For information about "Medium Cleaning" and "Powerful Cleaning,"
refer to pages regarding maintenance in "BN-20 Master Guide."

Click [Next] on the displayed screen.
3.

Bidirectional adjustment


Click [Test Print].
The test pattern is printed.

Read the on-screen instructions and then enter a value
in the [New Value] box.
Click in the computer's
task tray.
The BN-20 utility is displayed.




Click [Apply].
The value in [Present Value] changes to the entered value.

Click [Close].

Click [Next] on the displayed screen.
4.
Media feed correction

Click [Test Print].
The test pattern is printed.

Read the on-screen instructions and then enter a value
in the [New Value] box.

Click [Apply].
The value in [Present Value] changes to the value entered.

Click [Close].

Click [Next] on the displayed screen.
5.

Adjusting cutting


Click [Test Cut].
Test cutting is performed.

Read the on-screen instructions and then enter values in
the [Cut Force] box.

Click [Apply].
  
Repeat until adjustment is done to allow the two shapes
to peel off separately.

Click [Close].

Click [Next] on the displayed screen.
6.
Adjusting printing & cutting

Click [Print and Cut Pattern].
The test pattern is printed.

Follow the on-screen instructions and enter the values
for [New Value for Scanning] and [New Value for Feeding].

Click [Apply].
The values in [New Value for Scanning] and [New Value for Feeding]
change to "0."

Click [Close].

Click [Skip] on the displayed screen.
"Crop cut adjustment" will not be done here. It is not necessary for
printing and cutting.

Click [OK] on the displayed screen.
Adjustment is completed.