Common Keypad Displays - Security Command XR200 User Manual

Hide thumbs Also See for XR200:
Table of Contents

Advertisement

Common Keypad Displays

Listed below are several keypad messages you may see on the display. Follow the instructions in the Possible Solutions column to
correct the problem. In many cases, you will need to call a service person to correct the problem. Displays that are not discussed here
mean that your service representative should be called.
Message
Invalid Code
The user code you have entered is not recognized by the system.
Invalid Level
The code you have used does not have the authority level required to
perform the task you are attempting.
Closing Time
The scheduled has expired but the area has not been armed.
Late to Close
The system was not armed at its scheduled closing time.
AC Trouble
The system is not getting proper power.
Battery Trouble
The battery is either low or missing.
Phone Line 1 Trouble
The panel is looking for phone jack supervision.
System Trouble or
There is a problem with one or more components in the system.
Service Required
System Busy
The system is performing another task with a higher priority.
There is not a supervised device on the bus, low voltage or an open
4-Wire Bus Trouble
yellow wire, or two devices share the same address.
Transmit Fail
The panel has not succeeded to communicate with the central station.
Wireless Trouble
The wireless receiver is not communicating with the 472 900MZ
Interface.
Non-Polled Address
The device is not set to STD or FIRE in Device Setup of programming.
48
Meaning
XR200 User's Guide
Possible Solutions
Check the user code and try again.
Check the user level to see if you have the correct level set for the
code. Remember that you can only grant a user authority is you have
the same authority or greater: You can't give what you don't have.
Users still on the premise should arm the system or extend the
schedule to a later time.
Users still on the premise should arm the system or extend the
schedule to a later time.
Contact your representative.
Contact your representative.
Contact your representative.
Contact your representative.
Wait a short period of time and attempt the task again.
Contact your representative.
Contact your representative.
Contact your representative.
Contact your representative.
Appendix C

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the XR200 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents