Table of Contents
Advertisement
Schedules
User Code Level: 7 and above.
Function: The Schedules function allows you to enter into the
system the times at which you normally turn your burglary
protection ON and OFF each day of the week. Depending on your
system's programming, the ON time can be used to verify that the
burglary protection is armed. Also, the schedule's ON and OFF
times can be used to automatically arm or disarm the burglary
protection.
Schedules can also be used to restrict access to the system by users
with a 1 or 2 authority level assigned to their user codes.
Your system provides you with four different types of schedules:
1.
Permanent (PRM), Primary (PRI), and Secondary (SEC)
schedules occur at the same time until you change or delete
them.
2.
Temporary (TEMP) schedules occur only once and then
are cleared when they expire. These are used to allow
someone off hours access to the premises when used with a
level 1 or 2 code.
3.
Output (OUT) schedules allow you to set the times when
relay outputs connected to your system turn on and off
automatically.
4.
Extend (EXT) schedules allow you to extend today's closing
time schedule up to 23 hours and 59 minutes. This allows
the current schedule to ignore and not send a LATE TO
CLOSE message to the central station until the extended
schedule expires or the system is armed.
schedule is erased when it expires.
24
Setting an Arming and Disarming Schedule
1.
Access the User Menu and press COMMAND until SCHEDULES?
displays. Press any Select key.
2.
The keypad displays PRM TMP OUT EXT (or PRI SEC OUT
EXT). Press the Select key under PRM (or PRI). This allows
you to enter a schedule that remains in place until you
change or delete it.
3.
The keypad displays SUN MON TUE WED. Press the COMMAND
key to display THU FRI SAT. Press the Select key under the
day you want the schedule to begin.
Note: After selecting the day of the week for the schedule
to begin, the keypad displays any currently programmed
Opening and Closing times previously set for that day. This
feature allows you to review programmed schedules at any
time.
4.
If Opening and Closing times are displayed, the keypad then
displays DELETE
to enter new times.
5.
The keypad then displays OPENING TIME? followed by the
display MON – : AM PM. Enter the new opening time and
select AM or PM.
Enter all schedule times using a 12-hour clock. For example,
to enter 6 AM you would enter a 0 + 6 + 0 + 0 and press the
Select key under AM.
The keypad then displays CLOSING TIME? followed by the display
MON – :
AM PM. Enter the new closing time and select AM or
PM. Press the Select key under the day MON (whichever day is
The extend
displayed) allows you to scroll through the days of the week and
create a schedule window that spans multiple days.
XR200 User's Guide
KEEP. Press the Select key under DELETE
User Menu
Advertisement
Table of Contents
Need help?
Do you have a question about the XR200 and is the answer not in the manual?