Home/Away System Disarming - Security Command XR200 User Manual

Home/Away System Disarming

Disarming: While the system is armed, you can only enter the
premises through an entry/exit delay door without causing an
alarm. After opening the door, the Security Command keypad
sounds a prewarn tone to remind you to disarm the system. You
must disarm the system before the prewarn tone expires or an
alarm on the door zone will occur.
During the prewarn tone, the keypad displays ENTER CODE: #.
Enter your code to disarm the system.
Schedules: If you have programmed schedules for your system and
a level 2 code is entered outside of a schedule, the keypad displays
INVALID TIME. This lets the user know that they are disarming
outside of their authorized time. If your system is monitored, an
Unauthorized Entry report is sent to the central station.
Alarm Display: After disarming, the keypad dis plays any zones
that tripped or any transmission problems that occurred dur ing
the armed period. All burglary zones are then dis armed and any
by passed zones are automatically reset.
Disarmed Message: The keypad displays ALL SYSTEM OFF after the
system disarms.
Central Sta tion Report: A report of the system disarming can be
transmitted to the central sta tion. This is optional and can be
programmed for you at any time.
Disarming a Home/Away System
1. During the entry delay, the keypad displays ENTER CODE:.
Enter a 2-digit or 3-digit user code and press COMMAND, or
enter a 4-digit code without pressing COMMAND.
2. The keypad then displays any alarms or communication
problems that occurred during the armed period.
Arming and Disarming
3. The keypad next displays ALL SYSTEM OFF to conÞ rm the
system is disarmed.
Disarming During an Alarm
1. While the alarm bell or siren is sounding, enter a 2-digit or
3-digit user code and press COMMAND, or enter a 4-digit
user code. The keypad displays DISARM
2. Press the Select key under DISARM to disarm the system and
silence the alarm.
The keypad next displays ALL SYSTEM OFF to conÞ rm the
system is disarmed.
3. Press the Select key under SILENCE to stop the bell or siren
but NOT disarm the system.
If you do not press any Select key, or you press the
COMMAND key, the system will automatically disarm and
silence the alarm.
4. If your system is programmed to send an Abort (alarm
cancel) report to the central station, the keypad displays
ALARM SILENCED.
Note: If your system is programmed to send an Abort (alarm
cancel) report to the central station, selecting DISARM will
send this report to the central station. Be sure that you
want the alarm message to be cancelled before deciding to
disarm the system. If you do not want to disarm the system
and send the abort report, press SILENCE to only turn off
the alarm bells.
XR200 User's Guide
SILENCE.
13