Outputs On Off
User Code Level: 5 and above.
Function: Allows you to turn the system relay outputs on and off.
This function is used to individually turn your system's relay
outputs on and off. Your system may use these outputs to control
interior and exterior lighting, heating, air conditioning, or other
appliances.
The names and numbers of the relays connected to your system are
located in the System Setup section of this guide.
Turning the Outputs ON and OFF
1.
Access the User Menu.
2.
Press COMMAND until OUTPUTS ON/OFF? displays.
3.
Press any Select key to display OUTPUT: - ON OFF.
4.
Enter the output number you want to turn on or off. The
output number will appear in the display.
5.
With the output number displayed, press the Select key
under ON or OFF. The output is then turned on or off,
depending on your selection, and remains in that state until
you change it.
Under certain conditions, some outputs cannot be turned
on. If you select a restricted output, the keypad displays
CANNOT TURN ON.
6.
The system automatically removes the output number and a
new output number can be entered. Refer back to step 4.
Press the Back Arrow key to exit the User Menu.
User Menu
Zone Status
Displays a list of armed, bypassed, or alarmed zones. Also allows
you to check the status of individual zones. Zone Status can be
used to give you a list of zones by category or display the current
status of an individual zone number. The four categories are:
•
Armed Zones - zones that are currently armed.
•
Bypassed Zones - zones that are currently bypassed.
•
Alarmed Zones - zones that have gone into alarm during the
current or previ ous armed period.
•
Number - enter the number of any zone to check its
status.
Using the Zone Status Function
1.
Access the User Menu.
2.
Press COMMAND until ZONE STATUS? is displayed.
3.
Press any Select key to display ARM BYPS ALR NBR.
4.
Select ARM for a list of zones that are currently armed.
Scroll through the list by pressing the COMMAND key.
5.
Select BYPS for a list of zones that are currently bypassed.
6.
Select ALR for a list of zones that have gone into alarm
during the current or previous armed period.
7.
Press NBR and ZONE NO: - will be displayed.
8.
At the ZONE NO: - prompt, enter the zone number you want
to check and press COMMAND. The zone number and name
is displayed followed by its status. For example, a zone
status for zone 1 might be: BACK DOOR - OKAY.
XR200 User's Guide
17
Need help?
Do you have a question about the XR200 and is the answer not in the manual?