Area System Arming
Area Assignment: Your security system has been set up into
separate areas. The number of areas and their names are listed in
the back of this guide.
Arming or Disarming: You can arm and disarm all areas at one
time or each area individually. You can only arm or disarm areas
authorized for your user code.
Arm all or Selective Arming: After entering your user code, the
system allows you to arm either all of the areas to which you have
access or one or more selected areas. If you choose to arm all
areas, the system begins verifying that all zones in those areas
are in a good condition. If you choose to arm selected areas, the
system prompts you to choose the areas you want to arm.
Arming an Area System
1.
Press the COMMAND key until ARM
2.
Select ARM to arm the system.
3.
Enter your user code if required.
ALL?
NO YES.
4.
Select NO to arm only selected areas.
Select YES to arm all areas authorized for your user code.
Go to step 6.
5.
If you selected NO in step 4, the display begins to list each
area to which you have access followed by NO
Example: OFFICE
5a. Select YES for each area you want to arm.
5b. Select NO for each area you do not want to arm.
8
DISARM is displayed.
The display reads
Go to step 5.
NO YES
Note: You can also just press the area numbers you want to arm
while at the ALL?
AREAS: . The area numbers you select appear in the display. For
example: AREAS:
6.
The system displays any bypassed zones or faulted 24-hour
or Priority zones. A faulted Priority zone cannot be armed.
7.
At this point you can force arm or bypass any faulted zones.
A zone that is force armed restores into the system if it
later returns to normal. A zone that is bypassed remains
bypassed until the system is disarmed. See steps 7a through
7d.
7a. If a problem exists on a zone, the zone name and
problem is shown followed by: OKAY BYPASS STOP.
7b. Select OKAY to force arm the faulted zone.
7c. Select BYPASS to bypass all faulted zones being
displayed.
Note: You cannot bypass 24-hour zones.
7d. Select STOP to stop the system from arming. Correct
the zone problem(s) and return to step 1.
8.
The display reads SYSTEM ON if at least one area in the
system is armed, and ALL SYSTEM ON if all areas in the
system are armed.
9.
The keypad then displays the exit time in seconds and
YES.
counts down the remaining time: EXIT : ## (## = seconds
remaining) The exit zones arm when the delay time
expires.
XR200 User's Guide
NO
YES display. This changes the display to
2
4 . Press COMMAND when done.
Arming and Disarming
Need help?
Do you have a question about the XR200 and is the answer not in the manual?