User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
config router ospf virtif interval dead
This command configures the dead interval for the OSPF virtual interface on the virtual interface
identified by <areaid> and <neighbor>. The <neighbor> parameter is the IP address of the
neighbor. The range for <seconds> is 1 to 65535.
Default
Format
config router ospf virtif interval hello
This command configures the hello interval for the OSPF virtual interface on the virtual interface
identified by <areaid> and <neighbor>. The <neighbor> parameter is the IP address of the
neighbor. The range for <seconds> is 1 to 65535.
Default
Format
config router ospf virtif interval retransmit
This command configures the retransmit interval for the OSPF virtual interface on the virtual
interface identified by <areaid> and <neighbor>. The <neighbor> parameter is the IP address of
the neighbor. The range for <seconds> is 0 to 3600.
Default
Format
config router ospf exoverflowinterval
This command configures the exit overflow interval for OSPF. It describes the number of seconds
after entering Overflow state that a router will wait before attempting to leave the Overflow State.
This allows the router to again originate non-default AS-external-LSAs. When set to 0, the router
will not leave Overflow State until restarted. The range for <seconds> is 0 to 2147483647 seconds.
Default
Format
Routing Commands
40
config router ospf virtif interval dead <areaid>
<neighbor> <1-65535>
10
config router ospf virtif interval hello <areaid>
<neighbor> <1-65535>
5
config router ospf virtif interval retransmit <areaid>
<neighbor> <0-3600>
0
config router ospf exoverflowinterval <0-2147483647>
202-10009-01
8-27