Config Acl Rule Action; Config Acl Rule Match Dstip; Config Acl Rule Match Dstl4Port Keyword - NETGEAR ProSafe GSM7312 User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Format

config acl rule action

This command removes a rule from the ACL referenced by the parameter
identified by the
<rulenum>
evaluated.
Format
config acl rule action <aclid> <rulenum> <permit/deny>

config acl rule match dstip

This command specifies a destination IP Address and Mask match condition for an ACL rule
referenced by the
<aclid>
digit dotted-decimal numbers which represent the destination IP Address and IP Mask,
respectively.
Format
config acl rule match dstip <aclid> <rulenum> <ipaddr> <ipmask>

config acl rule match dstl4port keyword

This command specifies a destination layer 4 port match condition for an ACL rule referenced by
the and
<aclid> <rulenum>
currently has the values of
and . Each of these values translates into its equivalent port number, which is used as both the
www
start and end of a port range.
This command and the
specifying the destination layer 4 port range as a match condition. Either command can be used to
configure or modify the destination layer 4 port range.
Format
config acl rule match dstl4port keyword <aclid> <rulenum> <portkey>
ACL Commands
config acl rule delete <aclid> <rulenum>
parameter. The values of
and
<rulenum>.
. The
<portkey>
domain, echo, ftp, ftpdata, http, smtp, snmp, telnet, tftp
config acl match destl4port range
202-10009-01
or
permit deny
The and
<ipaddr> <ipmask>
parameter uses a single keyword notation and
command are two methods of
The rule is
<aclid>.
indicate how this rule is
parameters are 4-
,
10-3