User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Stub Mode
Import Summary LSAs
Metric Value
Metric Type
show router ospf area range
This command displays information about the area ranges for the specified <areaid>. The <areaid>
identifies the OSPF area whose ranges are being displayed.
Format
Area ID
IP Address
Subnet Mask
Lsdb Type
Advertisement
config router ospf area range create
This command creates a specified area range.
The <ipaddr> is a valid IP address.
The <subnetmask> is a valid subnet mask.
The [summ] is the lsdb type and is optional.
The [enable/disable] indicates advertise mode and is optional.
Format
config router ospf area range delete
This command deletes a specified area range.
The <ipaddr> is a valid IP address.
The <subnetmask> is a valid subnet mask.
Routing Commands
Represents whether the specified Area is a stub area or not. The possible values
are enabled and disabled. This is a configured value.
A number representing the Metric Value for the specified area.
The Default Metric Type for the specified Area.
show router ospf area range <areaid>
The area id of the requested OSPF area.
An IP Address which represents this area range.
A valid subnet mask for this area range.
The type of link advertisement associated with this area range.
Indicates whether the advertisement status is enabled or disabled.
config router ospf area range create <areaid> <ipaddr>
<subnetmask> [summ] [enable/disable]
202-10009-01
8-21