Config Diffserv Policy Shape Peak; Service Commands - NETGEAR ProSafe GSM7312 User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Restrictions
Policy Type

config diffserv policy shape peak

This command is used to establish peak rate traffic shaping for the specified class, which allows
transmissions for the class to exceed the committed information rate by sending excess traffic with
the understanding that it could be dropped by a downstream network element. The
and are the names of an existing DiffServ policy and class, respectively. Two rate
<classname>
parameters are used, a committed information rate and a peak information rate. Each of these rates
is specified in kilobits-per-second (Kbps) and is an integer from 1 to 4294967295. The peak rate
must be specified as equal to or greater than the committed rate.
Note: Queue depth management defaults to tail drop, but the config diffserv policy randomdrop
command can be used to change to a RED scheme.
Format
Restrictions
Policy Type
Incompatibilities

Service Commands

The 'service' command set is used in DiffServ to define:
Traffic Conditioning
Service Provisioning
The service commands attach a defined policy to a directional interface. Only one policy may be
assigned at any one time to an interface in a particular direction. The policy type (in, out) must
match the interface direction to which it is attached.
This set of commands consists of service addition/removal.
Differentiated Services
This shaping rate must not exceed the maximum link data rate of the interface to
which the policy is applied.
Out
config diffserv policy shape peak <policyname>
<classname> <1-4294967295> <1-4294967295>
Neither of the shaping rate parameters is allowed to exceed the maximum link
data rate of the interface to which the policy is applied.
Out
Expedite (all forms)
Assign a DiffServ traffic conditioning policy (as specified by the policy
commands) to an interface in the incoming direction
Assign a DiffServ service provisioning policy (as specified by the policy
commands) to an interface in the outgoing direction
202-10009-01
<policyname>
9-27