Show Diffserv Policy Detailed - NETGEAR ProSafe GSM7312 User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software

show diffserv policy detailed

This command displays all configuration information for the specified policy. The <policyname>
is the name of an existing DiffServ policy.
Format
Policy Name
Type
The following information is repeated for each class associated with this policy (only those policy
attributes actually configured are displayed):
Class Name
Mark CoS
Mark IP DSCP
Mark IP Precedence
Policing Style
Committed Rate (Kbps)
Committed Burst Size (KB)
Excess Burst Size (KB)
Peak Rate (Kbps)
Peak Burst Size (KB)
Conform Action
Conform DSCP Value
Conform IP Precedence Value This field shows the IP Precedence mark value if the conform action is
Exceed Action
Differentiated Services
show diffserv policy detailed <policyname>
The name of this policy.
The policy type, namely whether it is an inbound or outbound policy definition.
The name of this class.
Denotes the class of service value that is set in the 802.1p header of outbound
packets. This is not displayed if the config diffserv policy mark cos command
was not specified.
Denotes the mark/re-mark value used as the DSCP for traffic matching this
class. This is not displayed if the config diffserv policy mark ipdscp command
was not specified, or if policing is in use for the class under this policy.
Denotes the mark/re-mark value used as the IP Precedence for traffic matching
this class. This is not displayed if the config diffserv policy mark ipprecedence
command was not specified, or if either mark DSCP or policing is in use for the
class under this policy.
This field denotes the style of policing, if any, used (simple, single rate, or two
rate).
This field displays the committed rate, used in simple policing, single-rate
policing, and two-rate policing.
This field displays the committed burst size, used in simple policing, single-rate
policing, and two-rate policing.
This field displays the excess burst size, used in single-rate policing.
This field displays the peak rate, used in two-rate policing.
This field displays the peak burst size, used in two-rate policing.
The current setting for the action taken on a packet considered to conform to the
policing parameters. This is not displayed if policing is not in use for the class
under this policy.
This field shows the DSCP mark value if the conform action is markdscp.
markprec.
The current setting for the action taken on a packet considered to exceed to the
policing parameters. This is not displayed if policing not in use for the class
under this policy.
202-10009-01
9-31