Show Router Rip Interface Summary; Config Router Rip Adminmode; Config Router Rip Preference - NETGEAR ProSafe GSM7312 User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Default Metric
The following information will be invalid if the link state is down.
Bad Packets Received
Bad Routes Received
Updates Sent

show router rip interface summary

This command displays general information for each RIP interface. For this command to display
successful results routing must be enable per interface (i.e. config router rip interface <slot.port>
enable).
Format
Slot.Port
IP Address
Send Version
Receive Version
RIP Mode
Link State

config router rip adminmode

This command sets the administrative mode of RIP in the router to active or inactive.
Default
Format

config router rip preference

This command sets the route preference value of RIP in the router. Lower route preference values
are preferred when determining the best route.
Default
Format
8-12
A number which represents the metric used for default routes in RIP updates
originated on the specified interface. This is a configured value.
The number of RIP response packets received by the RIP process which were
subsequently discarded for any reason.
The number of routes contained in valid RIP packets that were ignored for any
reason.
The number of triggered RIP updates actually sent on this interface.
show router rip interface summary
The unit slot.port identifying each interface.
The IP source address used by the specified RIP interface.
The RIP version(s) used when sending updates on the specified interface. The
types are none, RIP-1, RIP-1c, RIP-2.
The RIP version(s) allowed when receiving updates from the specified interface.
The types are none, RIP-1, RIP-2, Both
RIP administrative mode of router RIP operation; enable activates, disable de-
activates it.
The mode of the interface (up or down).
disable
config router rip adminmode <enable|disable>
15
config router rip preference <0-255>
202-10009-01
Routing Commands