Post-Power On Check - H3C CR16000-M Installation Manual

Press Ctrl+D to access BASIC-BOOTWARE MENU...
Press Ctrl+T to start memory test
Booting Normal Extended BootWare
The Extended BootWare is self-decompressing.........Done.
...
BootWare Validating...
Press Ctrl+B to access EXTENDED-BOOTWARE MENU...
Enter 1 and press Enter on the BootWare main menu. The system starts loading and starting the
system image.
Enter your choice(0-9): 1
Loading the main image files...
Loading file flash:/temp-system.bin...........................
............................................................................
............................................................................
.............................Done.
Loading file flash:/temp-boot.bin.............................
......Done.
Image file flash:/temp-boot.bin is self-decompressing.........
................................................................Done.
System image is starting...
Line con0 is available.
Press ENTER to get started.
Press Enter. When <sysname> is displayed, the device enters user view and you can configure the
router.

Post-power on check

After the router starts up, verify that the router is operating correctly.
•
If the ventilation system operates correctly after the router is powered on, you can hear rotation
of fan trays and feel air exhausted from the air outlet vents.
•
If the router is operating correctly, the module LEDs will be in status as described in Table7-2. If
the LEDs are not in status as described in Table7-2, the router might be operating incorrectly.
For more information about the LEDs, see H3C CR16000-M Routers Hardware Information and
Specifications. To resolve the issues based on the LEDs, see "Troubleshooting".
Table7-2 LED status when the router is operating correctly
Module
MPU
LED
MGMENT
RUN
ACT
7-5
Status
LINK Steady on
ACT Flashing
Flashing (0.5 Hz)
Steady on