Connecting An Ac Power Cord - H3C CR16000-M Installation Manual

The router is shipped without filler panels in some power supply slots. The figures in this section are
for illustration only.
To install a power supply:
1. Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
For more information, see
2. Remove the filler panel, if any, from the target power supply slot.
3. Unpack the power supply.
4. As shown by callout 1 in Figure4-8, grasping the handle of the power supply with one hand and
supporting the power supply bottom with the other, push the power supply along the guide rails
into the slot.
5. Press the handle into the slot after the power supply is seated fully in the slot.
6. Use a Phillips screwdriver to fasten the captive screw on the power supply to secure the power
supply in the chassis.
Figure4-8 Installing a power supply

Connecting an AC power cord

CAUTION:
• Before you connect an AC power cord, make sure the circuit breaker for the power cord is turned
off.
• Use an AC power cord with a straight connector for the router
To connect an AC power cord:
1. Insert the connector of the power cord into the power receptacle on the power supply, and use
a releasable cable tie to secure the power cord to the nearby cable management bracket.
2. Connect the other end of the power cord to a power outlet of the AC power source.
"Attaching an ESD wrist
4-6
strap."