Table7-1 Pre-power on checklist
No.
1
2
3
4
Starting the router for the first time
Powering on the router
1.
Connect the power cords to the power outlets.
2.
Turn on the switch of the external power source.
3.
Open the protective cover over the power switches on the router and turn on the power
switches.
4.
Close the protective cover.
5.
Observe the power input status LEDs on the power supplies. If the LEDs are on, the power
cords are connected correctly. For more information about the power supply LEDs, see H3C
CR16000-M Routers Hardware Information and Specifications.
Figure7-3 Powering on the router
Observing startup information of the router
When the router starts up, following information is output on the configuration terminal.
NOTE:
Output information on the configuration terminal varies by software version.
System is starting...
Check items
The resistance from the chassis to earth is less than 1 ohm.
The power input voltage is as required by the router.
All fan trays are present.
The console cable is connected correctly, the configuration terminal has been open, and terminal
parameters have been configured.
7-4