Table of Contents
Advertisement
Technical alerts can't be turned off, but you can change how your alert notifies you:
Vibrate Only
l
Vibrate Only Exceptions: Urgent Low and technical alerts act differently; if you don't
acknowledge them, they will add sound. In the receiver, these alerts include: Urgent Low,
Replace Sensor Now, Sensor Failed, Set Date/Time, System Check, Very Low Battery,
Weak Charger.
For a list of system and technical alerts, go to the Glossary in the Safety Information chapter. For
more information on customizing all these alerts, go to the changing alerts sections of the Alerts
chapter. For more information on Vibrate Only in the receiver, go to the Customizing Sounds
section of the Alerts chapter.
58
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the G7 and is the answer not in the manual?
Questions and answers
My G7 sensor gave me a not paired on the pump and the phone app about 10 mins into warmup and keeps alerting that it’s not paired! Can’t find a way to stop the warmup on both pump and phone and just start new sensor then ask for a replacement
To stop the warmup process and start a new Dexcom G7 sensor after receiving a "not paired" alert on the pump and phone app:
1. Delete and reinstall the G7 app to resolve the pairing loop issue.
2. Restart the app and go through the setup screens again.
3. Begin the sensor setup on your pump first, especially if that is your preferred device.
4. When prompted, manually enter the sensor pairing code in the app.
5. If overlapping a sensor, insert and start the new sensor before the old one ends. This can help avoid a warmup delay.
These steps can help bypass the pairing issue and continue using the sensor without waiting for the full warmup.
This answer is automatically generated
Lost G7 receiver in my house. How do I find it?