Table of Contents
Advertisement
You can turn on and customize each of these alerts:
Go to Menu > Settings > Alerts
l
The Falling Fast alert is similar to the Urgent Low Soon alert:
Urgent Low Soon alert: Tells you when your glucose is falling so quickly it'll be at
l
55 mg/dL within 20 minutes.
Urgent Low Soon is tied to a specific sensor reading (55 mg/dL) and time (20 minutes).
Falling Fast alert: Also tells you your glucose is falling quickly, but you set the level that
l
triggers it and it isn't tied to time.
If your glucose is falling fast and is at or below 55 mg/dL, you'll get an Urgent Low alert, not a
Falling Fast alert.
Go to the changing alerts sections of the Alerts chapter for more information.
5 • Alerts |
Dexcom G7 Using Your Receiver
55
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the G7 and is the answer not in the manual?
Questions and answers
My G7 sensor gave me a not paired on the pump and the phone app about 10 mins into warmup and keeps alerting that it’s not paired! Can’t find a way to stop the warmup on both pump and phone and just start new sensor then ask for a replacement
To stop the warmup process and start a new Dexcom G7 sensor after receiving a "not paired" alert on the pump and phone app:
1. Delete and reinstall the G7 app to resolve the pairing loop issue.
2. Restart the app and go through the setup screens again.
3. Begin the sensor setup on your pump first, especially if that is your preferred device.
4. When prompted, manually enter the sensor pairing code in the app.
5. If overlapping a sensor, insert and start the new sensor before the old one ends. This can help avoid a warmup delay.
These steps can help bypass the pairing issue and continue using the sensor without waiting for the full warmup.
This answer is automatically generated