Table of Contents
Advertisement
1
130
mg/dL
3
6
7
4
6
7
8
3 Hours
20
2
1. Number: The most recent sensor reading.
2. Trend arrow: Where glucose is heading based on
300
3. Trend graph: The bigger dot on the right is the
5
150
100
40
4. 3 Hours
Now
Menu
the last few readings.
most recent sensor reading. The smaller dots show
past readings.
Change the number of hours
shown on the trend graph using the arrow buttons.
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the G7 and is the answer not in the manual?
Questions and answers
My G7 sensor gave me a not paired on the pump and the phone app about 10 mins into warmup and keeps alerting that it’s not paired! Can’t find a way to stop the warmup on both pump and phone and just start new sensor then ask for a replacement
To stop the warmup process and start a new Dexcom G7 sensor after receiving a "not paired" alert on the pump and phone app:
1. Delete and reinstall the G7 app to resolve the pairing loop issue.
2. Restart the app and go through the setup screens again.
3. Begin the sensor setup on your pump first, especially if that is your preferred device.
4. When prompted, manually enter the sensor pairing code in the app.
5. If overlapping a sensor, insert and start the new sensor before the old one ends. This can help avoid a warmup delay.
These steps can help bypass the pairing issue and continue using the sensor without waiting for the full warmup.
This answer is automatically generated
Lost G7 receiver in my house. How do I find it?