Juniper PTX1000 Hardware Manual page 83

Copyright © 2018, Juniper Networks, Inc.
root@% cli
Enter configuration mode.
4.
root> configure
Add a password to the root administration user account.
5.
[edit]
root@# set system root-authentication plain-text-password
New password: password
Retype new password: password
(Optional) Configure the name of the PTX1000. If the name includes spaces, enclose
6.
the name in quotation marks (" ").
[edit]
root@# set system host-name host-name
Configure the default gateway.
7.
[edit]
root@# set routing-options static route default next-hop address
Configure the IP address and prefix length for the management interface.
8.
[edit]
root@# set interfaces em0 unit 0 family inet address address/prefix-length
CAUTION: Although the CLI permits you to configure two management
Ethernet interfaces within the same subnet, only one interface is usable
and supported at a time.
NOTE: The RJ-45 management port
are both labeled
(Optional) Configure the static routes to remote prefixes with access to the
9.
management port.
[edit]
root@# set routing-options static route remote-prefix next-hop destination-ip retain
no-readvertise
Enable the Telnet service.
10.
[edit]
root@# set system services telnet
Chapter 3: Initial Installation and Configuration
and SFP management port
em0
.
MGMT
em1
83